Optical fiber cable 96 core ADSS8*12 single mode

This specification covers design and performance standards for single-mode fiber (G652 D) all-dielectric self-supporting (ADSS) cable. In the following, the structural and mechanical structure of 96-core ADSS8*12 single-mode optical fiber cable is discussed. All properties are fully compliant with the latest revision of TCI specifications.

Optical fiber cable 96 core ADSS8*12 single mode

PBN ADSS-SM is an all-dielectric aerial fiber optic cable capable of being used in aerial optical networks constructed with single-mode fiber conforming to ITU/TIA G652D. This cable is resistant to ultraviolet rays due to the use of black high-density polyethylene (HDPE). This cable is suitable for use in central resistant era applications and can be used with 2 to 144 optical fiber cores.

Features of 96-core ADSS8*12 single mode fiber optic cable
Waterproof
UV resistant
Rodent protection
single jacket
Single mode optical fiber
Optical fiber specifications
Fiber attenuation at 1310 nm: ≤ 0.34 dB/Km
Fiber attenuation at 1550 nm: ≤ 0.22 dB/km
Fiber attenuation at 1625 nm: ≤ 0.24 dB/km
Effective area: ≤ 72 µm
Mode field diameter (MFD) at 1310: 9.2 ± 0.4 um
Mode Field Diameter (MFD) at 1550: 10.4 ± 0.8 um
Cable cutoff (λcc): ≤ 1260 nm
PMD @ 1550 nm: ≤ 0.2 ??/√?m
Coating deviation ≤ 0.5 µm

Cable structure

Optical fiber
Central resistive element
loose tube
Filler gel
Swollen thread and tape for waterproofing
Relaxed thread
Outer jacket

Central resistance member

Fiber reinforced polymer (FRP) with a diameter of 2.5 μm is used as a central resistive element. Young’s modulus of FRP is 50,000 N/mm2 and water absorption is 0.1% maximum.

loose tube

Lovetubes are made of polybutene terephthalate (PBT) with a minimum thickness of 0.4 mm. The fibers are spirally placed in the loose tube to have the ability to expand and contract the fibers. In order to prevent water penetration, loose tubes are filled with thixotropic gel.

Cable core

Loose tubes and their fillers (if any) are located on the central resistive element. Fillers are polyethylene rods that are used to round the cable core when needed. It has a water-swollen thread wound around the central resistive element for waterproofing purposes. At the end, a binder thread is spirally wrapped around them to keep the core flat.

Swollen bar

To make the cable waterproof, the core is wrapped in inflatable tape. Inflating tape is also composed of corrosion inhibitors.

outer jacket

Black HDPE (High Density Polyethylene) according to ASTM-1248 covers the entire cable as a 2 mm thick outer jacket.

Ripcord

Under the outer jacket, two Ripcords are placed to assist the operator in removing the jacket.